SW-313-PIN Matched GaAs SPDT Switch, DC-3.0 GHz with TTL/CMOS Control Input Rev. V6 Features  Integral TTL Driver Functional Block Diagram  Low DC Power Consumption  Fast Switching Speed: 7 ns Typical  Hermetic Surface Mount Package  50 Ohm Nominal Impedance RFC GND  MIL-STD-883 Screening Available  Lead-Free CR-9 Package GND GND  260°C Reflow Compatible GND GND  RoHS* Compliant RF1 RF2 GND GND Description GND GND M/A-COM’s SW-313-PIN is a GaAs FET SPDT ab- Vcc GND Orientation Mark sorptive switch with integral silicon ASIC driver. Packaged in a 16-lead ceramic surface mount pack- C1 Vee age, this device offers excellent performance and repeatability from DC to 3 GHz while maintaining low power consumption. The SW-313-PIN is ideally suited for use where fast speed, low power con- sumption and broadband applications are required. MIL-STD-883 screening available. Pin Configuration Ordering Information Pin No. Function Pin No. Function 1 Vee 9 RFC Part Number Package 2 GND 10 GND SW-313-PIN Bulk Packaging 3 GND 11 GND SW-313-TB Sample Test Board 4 GND 12 RF1 5 RF2 13 GND Note: Reference Application Note M513 for reel size information. 6 GND 14 GND 7 GND 15 Vcc 8 GND 16 C1 The metal bottom of the case must be connected to RF and DC ground. * Restrictions on Hazardous Substances, European Union Directive 2002/95/EC. 111 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support

SW-313-PIN Matched GaAs SPDT Switch, DC-3.0 GHz with TTL/CMOS Control Input Rev. V6 Electrical Specifications: (From –55°C to +85°C), Z = 50 1,2 0 Parameter Test Conditions Frequency Units Min Typ Max Insertion Loss — DC - 3000 MHz dB — — 1.2 DC - 2000 MHz dB — — 1.1 DC - 1000 MHz dB — — 0.9 DC - 500 MHz dB — — 0.8 VSWR — DC - 3000 MHz Ratio — — 1.50:1 DC - 2000 MHz Ratio — — 1.40:1 DC - 1000 MHz Ratio — — 1.35:1 DC - 500 MHz Ratio — — 1.30:1 Isolation — DC - 3000 MHz dB 35 — — DC - 2000 MHz dB 43 — — DC - 1000 MHz dB 48 — — DC - 500 MHz dB 53 — — Trise, Tfall 10% to 90% — ns — 7 — Ton, Toff 1.3V CTL to 90% / 10% — ns — 18 — Transients In-Band — mV — 25 — 1 dB Compression Input Power 0.05 GHz dBm — +25 — 0.5 GHz to 3 GHz dBm — +30 — IP2 Two-Tone Input Power up to +5 0.05 GHz dBm — +60 — dBm 0.5 GHz to 3 GHz dBm — +65 — IP3 Two-Tone Input Power up to +5 0.05 GHz dBm — +40 — dBm 0.5 GHz to 3 GHz dBm — +46 — Vin Low 0V to 0.8V — µA — — 1 Vin High 2.0V to 5.0V — µA — — 1 Vcc +5.0V ± 10% — mA — — 1 Vee -5.0V to -8.0V — mA — — 1 1. All specifications apply when operated with bias voltages of +5V for Vcc and –5V for Vee. 2. When DC blocks are used, a 10K ohm return to GND is required on the RFC port. 222 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support

SW-313-PIN Matched GaAs SPDT Switch, DC-3.0 GHz with TTL/CMOS Control Input Rev. V6 Absolute Maximum Ratings 3,4 Parameter Absolute Maximum Truth Table (Switch) Max Input Power 50 MHz +27 dBm 500 - 3000 MHz +34 dBm Condition of Switch V -0.5V ≤ V ≤ +7.0V Control Input CC CC RF Common to Each RF Port V -8.5V ≤ V ≤ +0.5V EE EE C1 RF1 RF2 V - V -0.5V ≤ V - V ≤ 14.5V CC EE CC EE Vin5 -0.5V ≤ Vin ≤ V + 0.5V 0 On Off CC Operating Temperature -55°C to +125°C 1 Off On Storage Temperature -65°C to +150°C 0 = TTL Low; 1 = TTL High 3. Exceeding any one or combination of these limits may cause permanent damage to this device. 4. M/A-COM does not recommend sustained operation near these survivability limits. 5. Standard CMOS TTL interface, latch-up will occur if logic Typical Performance Curves signal is applied prior to power supply. Insertion Loss vs. Frequency Handling Procedures Please observe the following precautions to avoid 2.00 damage: 1.50 Static Sensitivity B) d Gallium Arsenide Integrated Circuits are sensitive s ( 1.00 s to electrostatic discharge (ESD) and can be o L damaged by static electricity. Proper ESD control 0.50 techniques should be used when handling these devices. 0.00 0.0 0.5 1.0 1.5 2.0 2.5 3 Frequency (GHz) Isolation vs. Frequency VSWR vs. Frequency VSWR (On) VSWR (Off) 80 2.20 70 2.00 60 B n d 50 1.80 o R ati 40 SW 1.60 ol 30 V s I 20 1.40 10 1.20 0 1.00 0.0 0.5 1.0 1.5 2.0 2.5 3 0.0 0.5 1.0 1.5 2.0 2.5 3 333 Frequency (GHz) Frequency (GHz) M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support

SW-313-PIN Matched GaAs SPDT Switch, DC-3.0 GHz with TTL/CMOS Control Input Rev. V6 Lead-Free, CR-9 Ceramic Package† † Reference Application Note M538 for lead-free solder reflow recommendations. 444 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support

SW-313-PIN Matched GaAs SPDT Switch, DC-3.0 GHz with TTL/CMOS Control Input Rev. V6 M/A-COM Technology Solutions Inc. All rights reserved. Information in this document is provided in connection with M/A-COM Technology Solutions Inc ("MACOM") products. These materials are provided by MACOM as a service to its customers and may be used for informational purposes only. Except as provided in MACOM's Terms and Conditions of Sale for such products or in any separate agreement related to this document, MACOM assumes no liability whatsoever. MACOM assumes no responsibility for errors or omissions in these materials. MACOM may make changes to specifications and product descriptions at any time, without notice. MACOM makes no commitment to update the information and shall have no responsibility whatsoever for conflicts or incompatibilities arising from future changes to its specifications and product descriptions. No license, express or implied, by estoppels or otherwise, to any intellectual property rights is granted by this document. THESE MATERIALS ARE PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, RELATING TO SALE AND/OR USE OF MACOM PRODUCTS INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, CONSEQUENTIAL OR INCIDENTAL DAMAGES, MERCHANTABILITY, OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. MACOM FURTHER DOES NOT WARRANT THE ACCURACY OR COMPLETENESS OF THE INFORMATION, TEXT, GRAPHICS OR OTHER ITEMS CONTAINED WITHIN THESE MATERIALS. MACOM SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION, LOST REVENUES OR LOST PROFITS, WHICH MAY RESULT FROM THE USE OF THESE MATERIALS. MACOM products are not intended for use in medical, lifesaving or life sustaining applications. MACOM customers using or selling MACOM products for use in such applications do so at their own risk and agree to fully indemnify MACOM for any damages resulting from such improper use or sale. 555 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support