SDP86XX Optoschmitt Detector FEATURES • Side-looking plastic package • 55¡ (nominal) acceptance angle • Wide sensitivity ranges • TTL/LSTTL/CMOS compatible • Buffer (SDP8600/8601/8602) or inverting (SDP8610/8611/8612) logic available • Three different lead spacing arrangements • Mechanically and spectrally matched to SEP8506 and SEP8706 infrared emitting diodes INFRA--6.TIF DESCRIPTION OUTLINE DIMENSIONSin inches (mm) The SDP86XX series is a family of single chip Tolerance 3 plc decimals ±0.005(0.12) Optoschmitt IC detectors molded in a side-looking black 2 plc decimals ±0.020(0.51) plastic package to minimize the effect of visible ambient light. The photodetector consists of a photodiode, amplifier, voltage regulator, Schmitt trigger and an NPN output transistor with a 10 kì (nominal) pull-up resistor. Output rise and fall times are independent of the rate of change of incident light. Detector sensitivity has been internally temperature compensated. Flexibility of use is enhanced by a choice of three different lead configurations; in-line (SDP8601/8611), 0.05 in.(1.27 mm) offset pin circle (SDP8600/8610) and 0.10 in. (2.54 mm) offset center lead (SDP8602/8612). Device Polarity: Buffer - Output is HI when incident light intensity is above the turn on threshold level. Inverter - Output is LO when incident light intensity is above the turn on threshold level. DIM_028.cdr h Honeywell reserves the right to make 200 changes in order to improve design and supply the best products possible.

SDP86XX Optoschmitt Detector ELECTRICAL CHARACTERISTICS PARAMETER SYMBOL MIN TYP MAX UNITS TEST CONDITIONS ABSOLUTE MAXIMUM RATINGS SCHEMATIC (25¡C Free-Air Temperature unless otherwise noted) Supply Voltage 12 V [À] Duration of Output Short to VÙÙ or Ground 1.0 sec Output Current 18 mA Operating Temperature Range -40¡C to 85¡C Storage Temperature Range -40¡C to 85¡C Soldering Temperature (5 sec) 240¡C Notes 1. Derate linearly from 25¡C to 5.5 V at 85¡C. Honeywell reserves the right to make h changes in order to improve design and 201 supply the best products possible.

SDP86XX Optoschmitt Detector SCHEMATIC SWITCHING TIME TEST CIRCUIT SCH_024.cdr cir_007.cdr SWITCHING WAVEFORM FOR BUFFERS SWITCHING WAVEFORM FOR cir_013.cdr INVERTERS cir_011.cdr Fig. 1 Responsivity vs Fig. 2 Threshold Irradiance vs Temperature Angular Displacement gra_065.ds4 gra_060.ds4 1.0 e 00..89 ce s n lit rvseaeeponR 000000......234567 lti iirrveaeadaR 00021.....34500 0.2 0.1 0.0 0.0 -60 -45 -30 -15 0 +15 +30 +45 +60 -40 -20 0 20 40 60 80 100 Angular displacement - degrees Temperature - °C h Honeywell reserves the right to make 202 changes in order to improve design and supply the best products possible.

SDP86XX Optoschmitt Detector Fig. 3 Output Rise Time (t²) and Output Fall Fig. 4 Delay Time vs Temperature Time (t¶) vs Temperature gra_061.ds4 gra_062.ds4 240 4.2 T)F 220 Symbol definition & test s 3.8 ll ti (aem 111246800000 circuit per figures l -ydeaµ 33..04 TPLH ti f()eeT&mR -sn 11022468000000 Rise time TFRall time TF ti ropagaonP 1122....4826 TPHL isR 0.0 -40 -20 0 20 40 60 80 100 -40 -20 0 20 40 60 80 100 Temperature - °C Ambient temperature - °C Fig. 5 Spectral Responsivity gra_050.ds4 1.0 0.9 e 0.8 s on 0.7 sp 0.6 e re 0.5 litvea 00..34 R 0.2 0.1 0.0 600 700 800 900 1000 1100 1200 Wavelength - nm All Performance Curves Show Typical Values Honeywell reserves the right to make h changes in order to improve design and 203 supply the best products possible.