PTV03010 3.3 Vin single output DC-DC CONVERTERS POLA Non-isolated 1 • 8 A output current NEW Product • 3.3 V input voltage • Wide-output voltage adjust (0.8 Vdc to 2.5 Vdc) • Auto-track™ sequencing* • Pre-bias start-up • Efficiencies up to 93% • Output ON/OFF inhibit • Vertical through-hole mounting • Point-of-Load-Alliance (POLA) compatible • Undervoltage lockout • Available RoHS compliant The PTV03010 is a non-isolated dc-dc converter from Artesyn under the Point of Load Alliance (POLA) standard. The vertical mounting option of the PTV03010 module provides performance in less than 20% of the space that is required by alternative solutions. The Auto-Track™ feature provides for sequencing between multiple modules, a function, which is becoming a necessity for powering advanced silicon including DSP’s, FPGA’sand ASIC’srequiring controlled power- up and power-down. The PTV03010 has an input voltage of 2.95 Vdc to 3.65 Vdc and offers a wide 0.8 Vdc to 2.5 Vdc output voltage range with up to 8 A output current, which allows for maximum design flexibility and a pathway for future upgrades. 2YEAR WARRANTY All specifications aretypical at nominal input, full load at 25 °C unless otherwise stated SPECIFICATIONS C =100 µF and 10 µF (Ceramic), C =0µF in out OUTPUT SPECIFICATIONS EMC CHARACTERISTICS Voltage adjustability (See Note 4) 0.8-2.5 Vdc Electrostatic discharge EN61000-4-2, IEC801-2 Conducted immunity EN61000-4-6 Setpoint accuracy (See Note 8) ±2.0% Vo Radiated immunity EN61000-4-3 Line regulation ±5 mV typ. GENERAL SPECIFICATIONS Load regulation ±5 mV typ. Efficiency (See Efficiency Table) 93% max. Total regulation (See Note 8) ±3.0% Vo Insulation voltage Non-isolated Minimum load 0A Switching frequency 550-650 kHz 600 kHz typ. Ripple and noise 20 MHz bandwidth 20 mV pk-pk Approvals and EN60950 Temperature co-efficient -40 ºC to +85 ºC ±0.5% Vo standards UL/cUL60950 Transient response 70 µsrecoverytime Material flammability UL94V-0 (See Note 5) Overshoot/undershoot 100 mV Dimensions (Lx W x H) 22.86 x 8.38 x 10.16 mm INPUT SPECIFICATIONS 0.90 x 0.330 x 0.400 in Input voltage range (See Note 3) 2.95-3.65 Vdc Weight 2.5 g (0.09 oz) Input standby current 10 mA typ. MTBF Telcordia SR-332 5,000,000 hours Remote ON/OFF (See Note 1) Positive logic ENVIRONMENTAL SPECIFICATIONS Undervoltage lockout (Increasing) 2.45 V typ. Thermal performance Operating ambient, -40 ºC to +85 ºC (See Note 2) temperature Track input current Pin 5 (See Note 6, 7) -0.13 mA Non-operating -40 ºC to +125 ºC PROTECTION International Safety StandardApprovals Overcurrent Auto reset 16 Atyp. UL/cUL CAN/CSA-C22.2 No. 60950 File No. E174104 TÜV Product Service (EN60950) Certificate No. B 04 06 38572 044 *Auto-track™ is a trade mark of CBReport and Certificate to IEC60950, Certificate No. Texas Instruments US/8292/UL File Name: ptv03010w.pdf Rev (02): 19 Dec 2005

PTV03010 3.3 Vin single output DC-DC CONVERTERS POLA Non-isolated 2 For the most current data and application support visit www.artesyn.com/powergroup/products.htm NEW Product OUTPUT OUTPUT OUTPUT INPUT OUTPUT EFFICIENCY REGULATION MODEL POWER CURRENT CURRENT (MAX.) VOLTAGE VOLTAGE (MIN.) (MAX.) (2) (MAX.) LINE LOAD NUMBER (9,10) 20 W 2.95-3.65 Vdc 0.8-2.5 Vdc 0 A 8 A 93% ±5 mV ±5 mV PTV03010W Part Number System with Options P T V 0 3 0 1 0 W A H Mounting Style(9) Product Family D = Horizontal Through-Hole (Matte Sn) Point of Load Alliance Compatible H =Horizontal Through-Hole (Sn/Pb) Mounting Version V = Vertical Pin Style A= Through-Hole Std. Pin Length (0.150”) Input Voltage 03 = 3.3 V Output Voltage Code W = Wide Output Current 01 = 8 A Mechanical Package Always 0 OOuuttppuutt VVoollttaaggee AAddjjuussttmmeenntt ooff tthhee PPTTVV0033001100 SSeerriieess The ultra-wide output voltage trim range offers major advantages to users who select the PTV03010. It is no longer necessary to purchase a variety of modules in order to cover different output voltages. The output voltage can be trimmed in a range of 0.8 Vdc to 2.5 Vdc. When the PTV03010 converter leaves the factory the output has been adjusted to the default voltage of 0.8 V. NNootteess EFFICIENCY TABLE (IO= IOMAX) 1 Remote ON/OFF. Positive logic ON: Pin 7 open; or V >(Vin - 0.5 V) OUTPUT VOLTAGE EFFICIENCY OFF: Pin 7 GND; or V <0.6 V. 2 See Figure 1 for safe operating curve. Vo = 2.5 V 93 3 A 100 µF electrolytic input capacitor is required for proper operation as well as a 10 µF high-frequency ceramic capacitor. The electrolytic Vo = 1.8 V 90 capacitor must be rated for a minimum of 300 mArms of ripple current. 4 An external output capacitor is not required for basic operation. Adding Vo = 1.5 V 89 100 µF of distributed capacitance at the load will improve the transient response. Vo = 1.2 V 87 56 1If Au/tµilsiz eloda dV osutet pw, il5l 0tr atoc k1 0a0p%pli eIodm vaoxl,t aCg3e =b y1 0±00 .µ3F .V(up to Vo set point). Vo = 1.0 V 85 7 The pre-bias start-up feature is not compatible with Auto-Track™. This is because when the module is under Auto-Track™control, it is fully active and will sink current if the output voltage is below that of a back-feeding source. Therefore to ensure a pre-bias hold-off, one of the following two techniques must be followed when input power is first applied to the module. The Auto-Track™function must either be disabled, or the module’s output held off using the Inhibit pin. Refer to Application Note 194 for more details. 8 The set-point voltage tolerance is affected by the tolerance and stability of Rset. The stated limit is unconditionally met if Rsethas a tolerance of 1% with 100/ºC or better temperature stability. 9 To order Pb-free (RoHS compatible) through-hole parts replace the mounting option ‘H’ with ‘D’, e.g. PTV03010WAD. 10 NOTICE: Some models do not support all options. Please contact your local Artesyn representative or use the on-line model number search tool at http://www.artesyn.com/powergroup/products.htm to find a suitable alternative. File Name: ptv03010w.pdf Rev (02): 19 Dec 2005

PTV03010 3.3 Vin single output DC-DC CONVERTERS POLA Non-isolated 3 For the most current data and application support visit www.artesyn.com/powergroup/products.htm NEW Product 90 100 80 C) E (º 70 %) 90 R PERATU 5600 N124000a000t cLLLoFFFnMMMv CIENCY ( 7800 Vout2110....5528VVVV M 40 FI E F 60 T 30 E 50 20 0 2 4 6 8 0 2 4 6 8 OUTPUT CURRENT (A) OUTPUT CURRENT (A) Figure 1 - Safe Operating Area Figure 2 - Efficiency vs Load Current Vin = 3.3 V, Output Voltage = 2.5 V (See Note A) Vin = 3.3 V (See Note B) NNootteess A SOA curves represent the conditions at which internal components are Track within the Artesyn derating guidelines. 5 B Characteristic data has been developed from actual products tested at Track 25 °C. This data is considered typical data for the converter. 2 Vin 8 Vin Vo 3 Vo PTVxx010 Inhibit GND Vo Adj 7 6 1 4 L O A Inhibit Rset D (Re1q0Cu01iureFd) (RCee1qCr0auu2mirFeicd) 0.10%5W O1p0Ct0io3unFal GND GND Figure 3 - Standard Application File Name: ptv03010w.pdf Rev (02): 19 Dec 2005

PTV03010 3.3 Vin single output DC-DC CONVERTERS POLA Non-isolated 4 For the most current data and application support visit www.artesyn.com/powergroup/products.htm NEW Product SIDE VIEW FRONT VIEW 0.330±0.008 (8.38±0.20) PCB 0.900 (22.86) 0.400 (10.16) 0.150 (3.81) 1 2 3 4 5 6 7 8 0.025 (0.64) Min 8 Places 0.020 (0.51) Plated Through Hole 0.100 (2.54) Dimensions in Inches (mm) Tolerances (unless otherwise specified) 0.100 (2.54) 2 Places ±0.030 (±0.76) 3 Places ±0.010 (±0.25) Figure 4 - Mechanical Drawing PIN CONNECTIONS PIN NO. FUNCTION 1 Ground 2 Vout 3 Vout 4 Vo Adjust 5 Track 6 Ground 7 Inhibit 8 Vin Datasheet © Artesyn Technologies®2005 The information and specifications contained in this datasheet are believed to be correct at time of publication. However, Artesyn Technologies accepts no responsibility for consequences arising from printing errors or inaccuracies. The information and specifications contained or described herein are subject to change in any manner at any time without notice. No rights under any patent accompany the sale of any such product(s) or information contained herein. Please consult our website for the following items: 4 Application Note www.artesyn.com File Name: ptv03010w.pdf Rev (02): 19 Dec 2005

Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: A rtesyn Embedded Technologies: PTV03010WAH