DSK-414 DSK-414 ELEELCETRCICT RDIOCU DBLOEU LBALYEE RLAYER CACPAACPIATOCRITSO “RDYSN “ADCYANP”ACAP” ®® Coin Cell Capacitors GREEN 70℃ CAP ●Reflow soldering method available. ●Unlike batteries, the number of charging / discharging cycles unlimited and rapid Low profile charging / discharging is possible. DSK DSK ●Unlike batteries, exceilent charge and discharge (414) (614) characteristics with no chemical reactions. ●φ4.8×1.71Lmm Max height type made lineup in the DSK series. Specifications Item Performance Series name series DSK Max. operating voltage (V) 3.3 Category temperature range (℃) ー10 to ＋70 Tolerance at rated capacitance (%) ー20 to ＋80 Rated capacitance (F) 0.07 Internal resistance (Ω Max.) 100 at 1 kHz Characteristics at high Percentage of capacitance change Within ±50% of the value at 20℃ and low temperature Internal resistance Less than ten times of the initial specified value. Test time 500 hours Endurance (70℃) Percentage of capacitance change Within ±30% of the initial measured value Internal resistance 5kΩ or less Shelf life (70℃) Test time : 500 hours ; Same as endurance. Applicable standards Conforms to JIS C5160-1 2009（ IEC 62391-1 2006) Outline Drawing Unit : mm Recommended land pattern size Unit : mm Terminal shaped : HL Terminal shaped : HR 22.8.±0＋ー000..11 1.0±0.20.7±0.2 L＋ー00..21 00..111.1±0.51.1±0.5±±001.6±0.2..0033 φD＋ー00.2 7.4 Max. 1.0±0.20.7±0.2 3.02 ＋.8±0,0 ー.10.1 1.6L6ー＋±00..210.050.1.1±0.511.1±0.5±01.6±0.2.03 φD＋ー00.2 7.4 Max. 32..55ーー0000..55 1.5±0.14.6±0.11.5±0.1 3.0 ＋0, ー0.1 1.66±0.05 2.0＋ー00.1 0.1±0.03 Polarity changesto terminal form. Sn plated Sn plated ＊Please consult with us about other terminal form Part numbering system (3.3V0.07F, terminal shaped : HL) DSK ̶ 3R3 H 703 T414 ̶ HL L Series code Max.operating voltage Rated capacitance Additional Terminal Taping symbol symbol symbol shaped symbol Part number is refer to following table. Standard Ratings E Max. operating voltage (V) Rated capacitance (F) ELNA Parts No. φD×L (mm) D L C DSK-3R3H703T414-HLL 3.3 0.07 4.8×1.4 DSK-3R3H703T414-HRL ＊Soldering conditions are described on page 191. NOTE : Design, Specifications are subject to change without notice. 210 It is recommended that you shall obtain technical specifications CAT.No.2015/2016E from ELNA to ensure that the component is suitable for your use.